{"product_id":"jandy-r0688600-variable-speed-drive-gen-ii-non-svrs","title":"Jandy R0688600 Variable Speed Drive — 2.2-2.7 HP Gen-II Non-SVRS, Fits VS PlusHP, VS FloPro \u0026 ePump — Genuine OEM","description":"\u003cp\u003eThe \u003cstrong\u003eJandy R0688600 Variable Speed Drive\u003c\/strong\u003e is the genuine OEM drive module for Jandy Gen-II permanent-magnet variable speed pumps in the \u003cstrong\u003e2.2-2.7 HP\u003c\/strong\u003e class. It is the electronics package that sits on top of the motor: it converts incoming single-phase power into the variable-frequency output the motor needs, and it carries the speed control logic, the schedule memory and the keypad.\u003c\/p\u003e\n\u003ch2\u003e⚠️ Drive Only — This Is Not a Motor\u003c\/h2\u003e\n\u003cp\u003eThis part replaces the drive electronics alone. If the motor itself has seized or burned out, you need the complete motor and drive assembly, \u003cstrong\u003eR0562201\u003c\/strong\u003e, instead. It is also \u003cstrong\u003eNon-SVRS\u003c\/strong\u003e and \u003cstrong\u003eGen-II\u003c\/strong\u003e specific — it will not serve SVRS pump variants or earlier drive generations.\u003c\/p\u003e\n\u003ch2\u003eCompatible Pumps\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003e\n\u003cstrong\u003eVS PlusHP:\u003c\/strong\u003e VSPHP270JEP, VSPHP270AUT\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eVS FloPro:\u003c\/strong\u003e VS-FHP2.0, VSFHP270JEP, VSFHP270AUT\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eePump:\u003c\/strong\u003e VSSHP220AUT, VSSHP270AUT\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eWhen This Is the Part You Need\u003c\/h2\u003e\n\u003cp\u003eA failed drive is the most common reason a Jandy variable speed pump stops working while the motor is still perfectly serviceable. Typical symptoms are a pump that will not power up at all, a blank or frozen keypad display, drive fault codes that return after a power cycle, or a pump that hums but never comes up to speed. Replacing the drive is a fraction of the cost of a new pump.\u003c\/p\u003e\n\u003ch2\u003eKey Features\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003e\n\u003cstrong\u003eGenuine Jandy OEM:\u003c\/strong\u003e correct control firmware and connector layout for the Gen-II motor.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eRestores full speed control:\u003c\/strong\u003e variable speed operation, on-board scheduling and keypad programming all return with the new drive.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eComponent-level repair:\u003c\/strong\u003e replaces the electronics rather than the entire pump.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eServes three pump families:\u003c\/strong\u003e one drive covers VS PlusHP, VS FloPro and ePump in this horsepower class.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eGen-II permanent-magnet design:\u003c\/strong\u003e matched to the ECM motor it drives.\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eSpecifications\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003e\n\u003cstrong\u003ePart Number:\u003c\/strong\u003e R0688600\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eType:\u003c\/strong\u003e Variable frequency drive module (drive only)\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eHorsepower Class:\u003c\/strong\u003e 2.2-2.7 HP\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eGeneration:\u003c\/strong\u003e Gen-II\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eSVRS:\u003c\/strong\u003e Non-SVRS\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eComplete Motor + Drive Assembly:\u003c\/strong\u003e R0562201\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eAlternate Part Numbers:\u003c\/strong\u003e TLD-101-7241, JDYR0688600, JNDR0688600\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eBrand:\u003c\/strong\u003e Jandy \/ Zodiac (Genuine OEM)\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eFrequently Asked Questions\u003c\/h2\u003e\n\u003ch3\u003eDoes this include the motor?\u003c\/h3\u003e\n\u003cp\u003eNo. This is the drive module only. If your motor has failed, the complete motor and drive assembly is \u003cstrong\u003eR0562201\u003c\/strong\u003e.\u003c\/p\u003e\n\u003ch3\u003eHow do I know whether my drive or my motor failed?\u003c\/h3\u003e\n\u003cp\u003eA drive fault usually shows as a dead or frozen display, a pump that will not start, or fault codes that persist through a power cycle while the motor spins freely by hand. A failed motor more often shows as a pump that tries to start and trips the breaker, or a shaft that will not turn. A pool professional can confirm with a resistance check across the motor windings.\u003c\/p\u003e\n\u003ch3\u003eWill this fit an SVRS pump?\u003c\/h3\u003e\n\u003cp\u003eNo. This is the Non-SVRS drive. SVRS-equipped pumps use a different drive and the two are not interchangeable.\u003c\/p\u003e\n\u003ch3\u003eWill it fit a Gen-I pump?\u003c\/h3\u003e\n\u003cp\u003eNo. This drive is specific to Gen-II pumps. Check the generation on your pump or motor label before ordering.\u003c\/p\u003e\n\u003ch3\u003eDo my saved schedules carry over?\u003c\/h3\u003e\n\u003cp\u003eNo. The schedules and speed presets live in the drive, so a new drive arrives with factory defaults. Note your speeds and run times before removing the old drive if you can still read them.\u003c\/p\u003e\n\u003ch3\u003eWho should install it?\u003c\/h3\u003e\n\u003cp\u003eA qualified pool professional or licensed electrician. The pump must be isolated at the breaker before the drive is opened, and permanent-magnet motors can generate voltage while the shaft is turning.\u003c\/p\u003e\n\u003cdiv class=\"ps4u-faq\"\u003e\n\u003ch2\u003eFrequently asked questions\u003c\/h2\u003e\n\u003ch3\u003eWhat is the part number for this drive?\u003c\/h3\u003e\n\u003cp\u003eJandy lists this drive under part number R0688600. Quote R0688600 when you cross-reference it against your equipment manual, an existing part, or a parts diagram, so you are comparing the same revision.\u003c\/p\u003e\n\u003ch3\u003eHow do I confirm this fits my equipment?\u003c\/h3\u003e\n\u003cp\u003eMatch the part number on the component you are replacing, or look it up in the parts list for your Jandy pump. If your model or serial number is not named on this page, send it to us before you order and we will confirm the fit.\u003c\/p\u003e\n\u003ch3\u003eDoes pump drive work need an electrician?\u003c\/h3\u003e\n\u003cp\u003ePool equipment sits under specific electrical code requirements covering bonding, grounding and GFCI protection. Cut power at the breaker before removing any drive cover, and have a licensed professional handle the supply side.\u003c\/p\u003e\n\u003ch3\u003eIs there a warranty on this part?\u003c\/h3\u003e\n\u003cp\u003eIt carries the standard Jandy manufacturer warranty. The terms are set by Jandy, and on some equipment the coverage only applies when a licensed professional performs the installation. Keep the receipt and packaging until you have confirmed correct operation.\u003c\/p\u003e\n\u003c\/div\u003e\n\u003cp\u003e\u003csmall\u003eCalifornia Proposition 65 Warning: This product can expose you to chemicals known to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.\u003c\/small\u003e\u003c\/p\u003e","brand":"Jandy","offers":[{"title":"Default Title","offer_id":67588756341053,"sku":"R0688600","price":898.0,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0968\/6741\/8429\/files\/jandy-gen-ii-variable-frequency-motor-22-27-hp-r0688600-vita-pool-supply-7191673_1200x1200_81713917-d153-4a12-badd-fb6e9bf3b4f7.png?v=1790616703","url":"https:\/\/poolsupply4u.com\/products\/jandy-r0688600-variable-speed-drive-gen-ii-non-svrs","provider":"PoolSupply 4U","version":"1.0","type":"link"}