Jandy Pro Series O-Ring, Lid Shpf/Shpm | R0446200
Couldn't load pickup availability
Got questions?
Feel free to get in touch
The Jandy R0446200 Pro Series O-Ring is a genuine OEM sealing component designed to provide a tight, leak-resistant seal for the lid of compatible Jandy pool equipment, including SHPF and SHPM pump or filter housings. O-rings are essential for preventing water loss and maintaining proper pressure within the system.
Over time, O-rings can compress, dry out, crack, or become damaged due to chemical exposure and repeated use. Replacing worn or stretched O-rings with the R0446200 helps restore a proper seal, improves system efficiency, and reduces the risk of leaks that can lead to pump cavitation or reduced filtration performance.
Jandy R0446200 Pro Series O-Ring Compatibility
-
Designed for Jandy Pro Series SHPF and SHPM pump/filter lids.
-
Compatible with pump and filter models that use lid O-rings in the SHPF/SHPM series.
-
Works with standard pool plumbing and equipment pads featuring Jandy Pro Series configurations.
-
OEM replacement for worn, brittle, or damaged lid seals to restore system integrity.
Frequently asked questions
How do I know which O-ring or gasket size I need?
Seals are specified by inside diameter and cross-section thickness, not by the equipment they sit in. Measure the old seal, or use the part number from your equipment's parts diagram, since visually similar rings are frequently a size apart.
What is the part number for this seal?
Pro Series lists this seal under part number R0446200. Quote R0446200 when you cross-reference against your equipment manual, an existing part, or a parts diagram, so you are comparing the same revision.
Should I lubricate the seal on installation?
Yes - a thin film of silicone-based pool lubricant helps the seal seat evenly and makes the next service far easier. Do not use petroleum-based grease, which swells and degrades most elastomers used in pool equipment.
How do I confirm this fits my equipment?
Match the part number stamped on the component you are replacing, or look it up in the parts list for your Pro Series equipment. If your model or serial number is not named on this page, send it to us before you order and we will confirm the fit.
How often do pool seals need replacing?
Seals are consumables. Replace them whenever the component is opened, and sooner if you see flattening, cracking, a chalky surface or any weeping. A failed seal on the suction side draws air and can make a pump lose prime.
Is there a warranty on this seal?
It carries the standard Pro Series manufacturer warranty. The terms are set by Pro Series, and on some equipment the coverage only applies when a licensed professional performs the installation. Keep the receipt and packaging until you have confirmed correct operation.