Jandy R0402800 AquaPure PureLink DC Cell Power Cord, 16 ft — Genuine Zodiac OEM
Couldn't load pickup availability
Got questions?
Feel free to get in touch
The Jandy R0402800 DC Power Cord is the genuine Zodiac/Jandy 16-foot replacement cable that connects an AquaPure® salt cell to its AquaPure or PureLink® power center. When a cracked jacket, corroded pins, or intermittent connection is causing "check cell" faults, replacing the cord is the fast, inexpensive fix.
Key Features
- Genuine Zodiac/Jandy OEM: Correct pin configuration and gauge for AquaPure and PureLink systems.
- 16-foot length: Standard factory run from equipment pad to cell.
- Fixes intermittent faults: A damaged cord is a very common cause of "check cell" errors that get misdiagnosed as a failed cell.
- Outdoor-rated construction: Jacket built for sun, moisture, and pool-pad chemical exposure.
- Simple swap: Unplug the old cord and connect the new one — no special tools.
- Far cheaper than a cell: Always rule out the cord before replacing an expensive salt cell.
Specifications
- Part Number: R0402800
- Type: DC power cord / cell cable
- Length: 16 feet
- Fits: Jandy AquaPure and PureLink salt chlorine generators, Nature2 Fusion Soft systems
- Brand: Jandy / Zodiac — genuine OEM
Frequently Asked Questions
What does the Jandy R0402800 connect?
It's the DC cord running between the AquaPure salt cell and the AquaPure or PureLink power center.
How long is it?
16 feet — the standard factory length for these systems.
Will this fix my "check cell" error?
Often, yes. Intermittent cell errors are more commonly a cable or connector problem than an actual cell failure. Inspect the cord for cracks and the pins for corrosion, and reseat the connector before assuming the cell is dead.
Which systems does it fit?
Jandy AquaPure and PureLink salt chlorine generators, and Nature2 Fusion Soft systems that use the same cell connection.
Is it hard to replace?
No — shut off power at the breaker, unplug the old cord at both ends, and connect the new one. No special tools required.
Is this genuine Jandy?
Yes — genuine Zodiac/Jandy OEM, which matters because pin configuration and conductor gauge must match the power center exactly.
Frequently asked questions
How many gallons is this salt system rated for?
The gallon rating is part of the model designation and is listed in the specification section above. Sizing up is normal practice: a cell rated above your pool volume runs fewer hours to hold the same chlorine level and generally lasts longer than one running at its limit.
What is the part number for this salt cell?
Zodiac lists this salt cell under part number R0402800. Quote R0402800 when you cross-reference against your equipment manual, an existing part, or a parts diagram, so you are comparing the same revision.
How long does a salt chlorinator cell last?
Cell life is measured in operating hours rather than calendar years, and most residential cells give several seasons of service. Life is shortened by high cyanuric acid, low water temperature operation, scale buildup on the plates, and running the cell at a high output percentage for long periods.
How do I confirm this fits my equipment?
Match the part number stamped on the component you are replacing, or look it up in the parts list for your Zodiac equipment. If your model or serial number is not named on this page, send it to us before you order and we will confirm the fit.
Do I need a matching power supply or control unit?
A cell and its power centre are matched as a pair; a cell will not generate chlorine on a power supply it was not designed for. Check whether this listing is the cell only, the power supply only, or a complete system before ordering.
Is there a warranty on this salt cell?
It carries the standard Zodiac manufacturer warranty. The terms are set by Zodiac, and on some equipment the coverage only applies when a licensed professional performs the installation. Keep the receipt and packaging until you have confirmed correct operation.